Rotary (Pulse) Dial Transfer; Pound Key (#) Transfer Required; Answering Machine And Phone Jacks Transfer Code; Fax And Fax/Modem Jacks Transfer Code - Radio Shack AFX-500 Owner's Manual

The Answer Any Jack feature does not operate after a call has
been transferred by the Automatic Answering Machine Trans-
fer feature, or using a single-tone transfer or a transfer code.
Related Commands:
"Distinctive Ring Service Detection" on Page 17
"Automatic No Answer Transfer" on Page 13
"Automatic Answering Machine Transfer" on Page 13

Rotary (Pulse) Dial Transfer

Touch-Tone Command: 07 = Off
Default Setting: On
This feature lets you use a rotary (pulse) phone to transfer a
call to another jack on the AFX-500. The Rotary (Pulse) Dial
Transfer code is 5 for the
jacks, and 3 for the and
FAX
On an outbound call, rotary dial transfers are allowed up to 20
seconds after dialing the last digit of the phone number.
When the AFX-500 is set to semiautomatic mode, rotary dial
transfer is allowed from any extension phone on the same line
as the AFX-500, as well as any phone connected to the AFX-
500.
When the AFX-500 is set to automatic mode, rotary dial trans-
fer is allowed only from a phone connected directly to the
AFX-500.
The calling party cannot initiate rotary dial transfers.

Pound Key (#) Transfer Required

Touch-Tone Command: 08 = Off
Default Setting: On
With this feature turned on, you or a caller must press
entering a transfer code or the Remote Access Security Code.
When this feature is turned off, you or the caller can transfer a
call by entering the transfer code without first pressing
or a caller make a mistake entering a transfer code, press
and re-enter the code.
Related Commands:
"Remote Access Security Code" on Page 12
17 = On
and
ANSWERING MACHINE
jacks.
FAX/MODEM
18 = On
Answering Machine and Phone Jacks Transfer
Code
Touch-Tone Command: 61xxxx
Default Setting: 0
This command sets the code required to transfer a call to the
ANSWERING MACHINE
to four digits, but it cannot include #.
Related Commands:

"Fax and Fax/Modem Jacks Transfer Code"

"Pound Key (#) Transfer Required"
Fax and Fax/Modem Jacks Transfer Code
PHONE
Touch-Tone Command: 62xx
Default Setting: 11
This command sets the code required to transfer a call to the
and
FAX FAX/MODEM
but it cannot include #.
Related Commands:

"Answering Machine and Phone Jacks Transfer Code"

"Pound Key (#) Transfer Required"
before
#
. If you
#
#
xxxx = 0–9999
and PHONE jacks. The code can be up
xx = 0–9999
jacks. The code can be up to four digits,
15