Connecting The Speaker Output Terminals; Connecting The Units - Pioneer GM-6500F Owner's Manual

Section
ID \
Connecting the units
A
wARNING
If the battery wire is not securely fixed to the term-
inal using the terminal screws, there is a risk of
overheating, malfunction and injury, including
minor burns.
1 Route battery wire from engine com-
partment to the vehicle interior.
After completing all other amplifier connec-
tions, finally connect the battery wire terminal
of the am pi ifier to the positive ((f)) battery
terminal.
CD
Positive
((f))
terminal
(g) Engine compartment
®
Vehicle interior
@
Fuse (30 A) x 2
®
Insert the 0-ring rubber grommet into the
vehicle body.
®
Drill a 14 mm hole into the vehicle body.
2 Twist the battery wire, ground wire
and system remote control wire.
Twist
---·
3 Attach lugs to wire ends.
Use pliers, etc., to crimp lugs to wires.
@En
CD
Lug (sold separately)
W
Battery wire
®
Ground wire
4 Connect the wires to the terminal.
Fix the wires securely with the terminal
screws.
CD
System remote control terminal
(g) Ground terminal
®
Power terminal
@ Terminal screws
®
Battery wire
®
Ground wire
(j)
System remote control wire[!]
Connecting the speaker
output terminals
1 Use wire cutters or a utility knife to
strip the end of the speaker wires to ex-
pose about 10 mm (3/8 in.) of wire and
then twist the wire.
Twist
-tz=i
r--r
10 mm
(3/8
inch)