Rear End Mounting Holes; Basic Functions; Reset; Selecting Cabinet Family - Yamaha Nexo NXAMP4X4 User Manual

(7) Rear end mounting holes

If the NXAMP is to be rack mounted and transported frequently, be sure to support the
rear end of the unit with mounting hardware that matches the size of the rack used.

Basic functions

Reset

You can reset the unit without powering off by simultaneously depressing buttons A, B &
"Select CH1" for 3 seconds at least.

Selecting cabinet family

Simultaneously depressing A & B buttons at power up or during device RESET accesses the
system change menu. Keep the A & B Buttons held until Load revision disappears from
screen (approx. 2 seconds). This will allow the selection of any cabinet in any family. Using
the rotary encoder, scroll through the configurations and press "B" to load the required
settings.

Select your cabinet set-up

In the 'Options' menu, choose "Systm Config", and you will be able to choose among the
different set-ups within the same cabinet family. (i.e. you don't have to modify the
amplifier to cabinet wiring).
QUICK START
0. FLAT - NO PROTN.
[4 ch amplifier]
42. GeoD PA WB
Back1-3 Front2-4
PAGE 18 OF 91
(For 3 seconds)
~
~
OK