Testing Your Pen; Interactive Pen Display - Wacom DTU-1031 User Manual

Interactive pen display

TESTING YOUR PEN

If the pen does not work as you expect, it is a good idea to first check the assigned functions or reset the
pen to its default conditions. A quick way to reset a pen to its default settings is to remove it from the T
list by clicking on the list's [ – ] button. After the pen has been removed, place it back onto the display
screen surface and the pen will be re-added to the T
Open the Wacom tablet control panel and click on the A
on the D ... button to open the D
IAGNOSE
dynamic information about the interactive pen display and pen. This information is used when testing the
pen display and your pen.
If more than one pen display unit is connected to your system, be sure to select the unit for which you are
testing in the T I
ABLET NFO
Note: If the pen switch is set to R
pressed. In this case you may want to change the switch's function before testing.
1. While observing the P
screen. A value for P
2. Move your tool along the pen display screen surface. The X and Y Data values should change to reflect
the tool position.
3. Test your pen switch. The pen display status LED should light blue each time you click with the pen tip
or press the switch.
• Press on the display screen surface with the pen tip. The S
should change. (P
approximately 100% when full pressure is applied.)
• Next, press the switch without pressing the tip to the display screen surface and the S
should change.
4. When you are done, click on the C
Contents Index
IAGNOSTICS
column.
M or O
ADIAL ENU
D I column, bring your pen within 5 mm (0.2 inch) of the display
OINTING EVICE NFO
, the D N
ROXIMITY EVICE
should change from approximately 0% with no pressure applied to
RESSURE
button to exit the dialog box.
LOSE
Contents Index
list with its default settings.
OOL
button. In the dialog box that appears, click
BOUT
dialog box. The D
/R ..., that function will occur when the switch is
PEN UN
, and D T
AME EVICE YPE
WITCHES
dialog box displays
IAGNOSTICS
should be displayed.
state and P
RESSURE
39
OOL
value
state
WITCHES
39