Replacing The Pen Tip; Interactive Pen Display - Wacom DTU-1031 User Manual

Interactive pen display

REPLACING THE PEN TIP

The pen tip (nib) will wear with normal use. Excessive pressure will cause it to wear sooner. If your pen
display has a coated surface a worn nib may cause damage. To avoid this, periodic tip replacement is
recommended.
When the nib gets too short or develops a sharp edge, replace it with one of the extra nibs that came with
the pen.
Clasp the old nib with a Wacom nib
extraction tool, pair of tweezers,
needle-nosed pliers, or similar
instrument and pull it straight out of
the pen.
Replace the pen nib when it gets too short, or less than 1 mm (0.04 inch).
Warning
Choking hazard. Prevent children from swallowing the pen nib or pen switch. The pen nib or switch may
accidentally be pulled out if children are biting on them.
Important: When not in use, place the pen in the pen storage compartment or the pen stand, or lay it flat on
your desk. Take care not to damage the pen nib when inserting or removing the pen from the
storage compartment. To maintain the sensitivity of your pen, do not store the tool in such a way
that it will rest on its tip.
Contents Index
Contents Index
Slide the end of the new nib straight
into the barrel of the pen. Firmly push
the nib until it stops. The new nib will
slide into the correct position.
50
50