Testing The Expresskeys, Rocker Ring And Center Button; Testing A Pen - Wacom cintiq companion User Manual

TESTING THE EXPRESSKEYS, ROCKER RING, AND CENTER BUTTON
If you are in Desktop Mode, use the following procedures to test these features.
1. With the D
IAGNOSTICS
Rocker Ring button. Be sure to select the pen display you are testing from the T
2. Test the ExpressKeys, Rocker Ring buttons or Center Button by pressing them one at a time. Each time
you press a key, position or button, its number is shown next to either the L
B category, depending on which key or position you are testing.
UTTONS
3. When you are done, click the
Important: Some applications can override and control the ExpressKey or Rocker Ring functions.
Consider closing any open applications except the Wacom Tablet control panel when testing the
ExpressKeys or Rocker Ring. For details, see

TESTING A PEN

1. With the D
IAGNOSTICS
your pen within 5 mm (0.2 inch) of the screen. A value for P
a D S/N (serial number) should be displayed. Be sure to select the pen display you are testing from
EVICE
the T I column.
ABLET NFO
2. Move your tool along the pen screen surface. The X and Y D
position.
• Press on the screen surface with the tool tip. The S
change. P
RESSURE
approximately 100% when full pressure is applied.
• Next, press the side switch without pressing the tip to the tablet. The S
change. For the Pro Pen, do this for both positions of the switch.
Pen
S states
WITCHES
Airbrush
S states
WITCHES
• Press the eraser to the screen. The S
should change from approximately 0% with no pressure applied to approximately 100% when full
pressure is applied.
• For the optional Airbrush, move the fingerwheel forward. The W
value of approximately 0 when the fingerwheel is all the way forward. Move the fingerwheel
backward. The W
way back.
Contents
dialog box open, observe the T
button to exit the dialog box.
C
LOSE
dialog box open, and while observing the P
should change from approximately 0% with no pressure applied to
Tip = 1
Side switch (lower position) = 2
Side switch (upper position) = 3
Eraser = 1
Tip = 1
Side switch = 2
Eraser = 1
WITCHES
value should increase to approximately 1000 when the fingerwheel is all the
HEEL
Contents Index
Index
I column as you test each ExpressKey or
ABLET NFO
using applications integrated for tablet
OINTING
, the D
ROXIMITY
values should change to reflect the tool
ATA
state and P
WITCHES
state and P
RESSURE
HEEL
I column.
ABLET NFO
B or R
EFT UTTONS
control.
D I column, bring
EVICE NFO
N , D
EVICE AME EVICE
value should
RESSURE
state should
WITCHES
value should change. P
value should decrease to a
67
IGHT
T , and
YPE
RESSURE
67