Standard Horizon CP150 Owner's Manual page 72

example in order to transmit weather forecast, to indicate the opening of a bridge, ...). The default setting
is On.
'MENU' + "MAP SETUP" + 'ENTER' + "NAV AIDS SETTINGS" + 'ENTER' + "SIGNALS" + 'ENTER'
Simulation
Used in order to use your chartplotter without input data. It generates a display with a moving vessel,
so that you can practice using the controls in safety.
Simulation Mode
Enables (On) or disables (Off) the Simulation. The default setting is Off.
'MENU' + "ADVANCED SETUP" + 'ENTER' + "SIMULATION" + 'ENTER' + "SIMULATION MODE" + 'ENTER'
SNR = Signal to Noise Ratio
The ratio of the magnitude of a signal that of the noise (interference).
SOG = Speed Over Ground
A calculation of the rate of movement of the ship over the ground.
(NMEA) SOG Trend page
'MENU' + "NMEA DISPLAY" + 'ENTER' + "SOG TREND" + 'ENTER'
Shows the graph of the Vessel Speed received from the NMEA Port. Pressing 'ZOOM IN'/'ZOOM OUT'
changes the time scale.
Speed
The current velocity at which you are travelling, relative to a ground location.
Speed Filter
Turns On/Off the Speed Filter. When it is On, you can filter the speed of the ship, to optimize it. The
default setting is Off.
'MENU' + "ADVANCED SETUP" + 'ENTER' + "FIX " + 'ENTER' + "SPEED FILTER" + 'ENTER'
Speed (Simulation)
Sets the value for speed in the Simulation mode. The default setting is 01.0 Kts.
'MENU' + "ADVANCED SETUP" + 'ENTER' + "SIMULATION" + 'ENTER' + "SPEED" + 'ENTER'
Speed (Unit)
Sets the speed unit among Kts = knots, Mph = miles per hour e Kmh = kilometers per hour. The default
setting is Kts.
'MENU' + "GENERAL SETUP" + 'ENTER' + "UNITS OF MEASURE" + 'ENTER' + "SPEED" + 'ENTER'
Spot Soundings
Turns On/Off the displaying of Spot Soundings (the depth of the water in a specific and charted
position). The default setting is On.
'MENU' + "MAP SETUP" + 'ENTER' + "MARINE SETTINGS" + 'ENTER' +"SPOT SOUNDINGS" + 'ENTER'
Static Navigation
Sets up a threshold for the speed. When the speed received from the positioning device is under that
threshold, the chartplotter displays zero. The default value is On.
'MENU' + "ADVANCED SETUP" + 'ENTER' + "INPUT/OUTPUT" + 'ENTER' + "INTERNAL GPS SETUP" +
'ENTER' + "STATIC NAVIGATION" + 'ENTER'
Step Unit (Track)
Choose Distance (Dist) - the chartplotter can store a fix when the distance from its last stored position
is greater than a defined distance; Time - the chartplotter can store a fix after a defined time; Auto -
the software decides when storing a position, on the basis of the straight or curved Track. The default
setting is Time.
Page 74
Figure 8h - SOG Graph page
GPS Chart 150