Standard Horizon CP150 Owner's Manual page 62

temperatures and prevalent winds. Some may be temporary, others permanent.
Cursor Control
Enables (On)/disables (Off) the cursor control. The default setting is Off.
'MENU' + "ADVANCED SETUP" + 'ENTER' + "SIMULATION" + 'ENTER' + "CURSOR CONTROL" + 'ENTER'
(NMEA) Data page
'MENU' + "NMEA DISPLAY" + 'ENTER' + "DATA" + 'ENTER'
Shows the stream of NMEA-0183 sentences read from the NMEA port. Pressing 'ENTER' stops/starts
alternatively the page update.
Data Window
It is possible to customize the data window layout among None (only charts), General (text area on the
right side of the screen), 1line small, 1 line large, 2 lines small. The default setting is General.
'MENU' + "GENERAL SETUP" + 'ENTER' + "DATA WINDOW" + 'ENTER'
Date (Simulation)
Sets the date of the simulated fix. Inserts date using the ShuttlePoint knob.
'MENU' + "ADVANCED SETUP" + 'ENTER' + "SIMULATION" + 'ENTER' + "DATE" + 'ENTER'
Date Format
Sets the preferred date between MM-D-YY and DD-MM-YY. The default setting is MM-DD-YY.
'MENU' + "GENERAL SETUP" + 'ENTER' + "TIME FORMAT" + 'ENTER'
Datum
The Latitude and Longitude lines printed on any map are based on certain models of the shape of the
earth: these models are called Datum or Coordinate Systems. There are many different Datum in use,
each one gives different Lat/Lon positions for an identical point on the surface of the earth (see Part
A of " Handbook").
Default
Indicates a value or a setting which is used if the user has not defined a particular value. You can modify
this value using the menu settings.
Delete (Track)
To clear the stored Track.
'MENU' + "TRACK" + 'ENTER' + "DELETE" + 'ENTER' + "YES" + 'ENTER'
Delete (file)
Deletes file from User C-CARD.
'MENU' + "USER C-CARD" + 'ENTER' + "DELETE" + 'ENTER'
Delete (Route)
To delete the selected Route.
'MENU' + "ROUTE" + 'ENTER' + "DELETE" + 'ENTER' + "YES" + 'ENTER'
Depth (Unit)
Sets the depth units among Ft = Feet, FM = Fathoms and Mt = Meters. The default setting is Mt.
'MENU' + "GENERAL SETUP" + 'ENTER' + "UNITS OF MEASURE" + 'ENTER' + "DEPTH" + 'ENTER'
Depth Alarm
Sets the minimum depth limit for activating the acoustic alarm if any depth received from the NMEA
input is below it. The default setting is Off.
'MENU' + "ADVANCED SETUP" + 'ENTER' + "ALARMS" + 'ENTER' + "DEPTH ALARM"
Page 64
Figure 8a - NMEA Data Page
GPS Chart 150