Pc Health Status - ECS PF21 Extreme User Manual

Init Display First [PCI Slot]
Use this item to specify the initial display to be the PCI slot or the graphics chip
integrated on the motherboard.
Reset Configuration Data [Disabled]
If your enable this item and restart the system, any Plug and Play configuration
data stored in the BIOS Setup is cleared from memory.
Resources Controlled By [Auto (ESCD)]
You should leave this item at the default Auto (ESCD). Under this setting, the
system dynamically allocates resources to Plug and Play devices as they are
required. If you can't get a legacy ISA expension card to work properly, you might
be able to solve the problem by changing this item to Manual, and them opening up
the IRQ Resources submenu.
PCI/VGA Palette Snoop [Disabled]
This item is designed to overcome problem that can be caused by some non-
standard VGA cards. This board includes a built-in VGA system that does not
required palette snooping so you must leave this item disabled.
Assign IRQ For USB [Enabled]
Names the interrupt request (IRQ) line assigned to the USB on your system. Activity
of the selected IRQ always awakens the system.
INT Pin 1-8 Assignment [Auto]
Identify the interrupt request (IRQ) line assigned to the USB on your system.
Activity of the selected IRQ always awakens the system.
3-16

3.3-7 PC Health Status

On motherboards that support hardware monitoring, this item lets you
Phoenix-AwardBIOS CMOS Setup Utility

PC Health Status

Case Open Warning [Disabled]
Case has been CLOSING
Shutdown Temperature [Disabled]
Current System Temp
Current CPU1 Temperature
NBFAN1
CPU FAN
CAS FAN
CPU Vcore
1.5V
3.3V
Smart CPUFan Function [Disabled]
X
CPUFan Tolerance Value 5
: Move Enter: Select +/-/PU/PD:Value
F5:Previous Values F6:Fail-Safe Defaults
Case Open Warning [Disabled]
This item enables or disables the warning if the case is opened up, and the item
below indicates the current the status of the case.
Shutdown Temperature [Disabled]
Enables you to set the maximum temperature the system can reach before powering
down.
Item Help
Menu Level
F10:Save ESC:Exit F1: General Help
F7:Optimized Defaults