Pc Health Status Option - ECS L4S5MG/GL Manual

Resources Controlled By (Auto(ESCD))
You should leave this item at the default Auto(ESCD). Under this setting, the
system dynamically allocates resources to Plug and Play devices as they are
required.
If you cannot get a legacy ISA (Industry Standard Architecture) expansion
card to work properly, you might be able to solve the problem by changing this
item to Manual, and then opening up the IRQ Resources submenu.
In the IRQ Resources submenu, if you assign an IRQ to Legacy ISA, then that
Interrupt Request Line is reserved for a legacy ISA expansion card. Press
<Esc> to close the IRQ Resources submenu.
PCI/VGA Palette Snoop (Disabled)
This item is designed to overcome problems that can be caused by some non-
standard VGA cards. This board includes a built-in VGA system that does not
require palette snooping so you must leave this item disabled.
INT Pin 1-8 Assignment (Auto)
Identifies the interrupt request (IRQ) line assigned to a device connected to
the PCI interface of your system.

PC Health Status Option

On mainboards that support hardware monitoring, this item lets you monitor
the parameters for critical voltages, critical temperatures, and fan speeds.
CMOS Setup Utility – Copyright (C) 1984 – 2001 Award Software
Shutdown Temperature
CPU Core Voltage
Vcc 1.8V
Vcc 3.3V
Vcc 5.0V
+12V
StandBy 3.3V
StandBy 5.0V
Voltage Battery
CPU Temperature
System Temperature
CPU Fan Speed
CHS Fan1 Speed
BAK Fan1 Speed
↑ ↓ → ← : MoveEnter : Select
F5:Previous Values
Shutdown Temperature
Enables you to set the maximum temperature the system can reach before
powering down.
PC Health Status
[Disabled ]
+/-/PU/PD:Value: F10: Save ESC: Exit F1:General Help
F6:Fail-Safe Defaults F7:Optimized Defaults
41
Item Help
Menu Level