Denon DBT-3313UD Owner's Manual page 53

Remote control settings
(remote control side)
Switches when this unit remote control operates another DENON
BD players in the vicinity.
Set the remote control code simultaneously on the unit, too
(vpage 41 "Remote ID").
1
Hold POWER X and OPEN/
CLOSE 5
pressed simultaneously.
While these buttons are held pressed,
the remote control signal transmission/
status display flashes twice, and the
remote control enters Setup mode.
2
When the number button " 1 " is pressed, the remote
control ID is set to "DENON 1".
When the number button " 2 " is pressed, the remote
control ID is set to "DENON 2".
When number key input is completed and the remote control
signal transmission/status display flashes twice, the settings for
the remote control are completed.
If the signal code of the remote control does not match the signal
code of the unit, the remote control code set on the unit is shown on
the display.
GExampleH
If the code setting on the unit is "DENON 1", and the setting on the
remote control is "2", "PLAYER 1" is shown on the display.
DVD
NOTE
• If you made the remote control settings incorrectly, the remote
control signal transmission/status display flashes for 2 seconds, and
then goes off. If this happens, the settings are incorrect and retry
the settings.
• Match the signal code of the remote control with the signal code of
the unit. If the remote control code is different, you cannot operate
the this unit with the remote control.
• Even if you change the remote control code, set the SETUP menu
"Others"–"Legacy Remote" (vpage
operating this unit with a remote control other than DENON's.
50
Remote control unit
41) to "Off" when