Denon DBT-3313UD Owner's Manual page 31

Video resolution
This section is for making the settings for video output resolution. Set them depending on the connected
television.
Press VIDEO RESOLUTION .
• The resolution is changed as shown below each time
pressed.
• You cannot set resolution individually for each HDMI output.
VIDEO RESOLUTION
• When you press and hold
on the display, "HDMI INIT" appears on the display and the setting returns to
the default.
• The default settings is underlined.
Auto Source Direct
(Auto) (Source direct)
1080P24 1080P
(1080 progressive, 24-frame) (1080 progressive)
DVD
VIDEO RESOLUTION
is
with the resolution appearing
480/576i 480/576P
(480/576 interlaced) (480/576 progressive)
720P
1080i
(1080 interlaced) (720 progressive)
• If the video resolution is not set to "Auto", set it to correspond with the resolution of your television/AV
receiver.
• Images will not be projected normally if the television/AV receiver resolution and this unit's output
resolution do not match.
• Audio and video will be temporarily interrupted if the power of the connected device currently playing is
turned off, or the input is switched.
• When you change the video resolution of the unit, it takes a few seconds up to about 10 seconds for
validation between the unit and the connected device. Audio/video is not output during this period.
28
Settings enabled during playback