Char-Broil 463262812 Product Manual page 17

7
Insert flange on right side shelf into side shelf brackets on side of firebox, shown A.
Attach rear of shelf using one 1/4-20x3/4" screw, 7mm lock washer, 7mm
1/4-20x1½" screw, 7mm lock washer and 7mm flat washer in lower hole, shown B/C.
Attach front of shelf and fascia using
#8x3/8" self-tapping screw with large flat washer, shown
Remove the four screws and washers factory attached to the Auto Clean valve bracket. Position Auto Clean valve bracket
beneath right side shelf fascia so that valve stem comes through larger center hole in fascia. Align the four holes on valve
bracket with the four holes on fascia. Secure using screws and washers that were removed from bracket, shown F.
Place the blank bezel over valve stem on front side of the fascia. Align small holes on bezel with the holes on fascia.
Attach using two #8-32x3/8" screws and 4mm lock washers. Press control knob on to valve stem, shown G.
E
Back of main control panel
F
Screws and Washers
removed from valve bracket
Auto Clean
valve bracket
valve stem
two
1/4-20x3/4"
Rear of Shelf
A
1/4-20x3/4" screw
7mm flat
washer
Igniter Switch
1/4-20x3/4"
screw
washer and 1/4" nut in upper hole; using one
flat
screws, 7mm flat washers,
C/D/E.
B
1/4-20x1½" screw
7mm lock
washer
D
#8x3/8" tapping
screw
large flat
washer
7mm lock
washer
1/4"nut
Note: Insert this screw from
7mm flat
washer
G
knob
bezel(blank)
7mm lock washers and 1/4" nuts, and one
7mm lock
washer
7mm flat
washer
1/4"nut
7mm lock
washer
1/4"nut
1/4-20x3/4" screw
the back of main control
panel
#8-32x3/8" screw
4mm lock
washer
valve stem
Meijer.com
C
7mm flat
washer
17