Table of Contents
Advertisement
5
On back of grill, place upper back panel between side panels and above lower back panel. Secure upper back panel, in
lower hole, using one 1/4-20x1½" screw, 7mm lock washer, and 7mm flat washer on each side.
Do not fully tighten screws until side shelf installation is complete in later steps.
1/4-20x1½"
7mm lock
washer
screw
6
Pull out the knobs from control panel. Insert temperature gauge stem into the biger hole above knob bezel,shown A.
Make sure the gauge is pushed in as far as it will go, then push the gauge downward until it clips into the panel, as
shown in B/C. Re-install the knobs.
Temperature gauge
Knob
16
7mm flat
washer
Control panel
Knob bezel
Meijer.com
Upper back panel
Temperature gauge stem
A
B
Back of the panel
C
Advertisement
Table of Contents
Troubleshooting
