Fujitsu M4099D Operator's Manual page 57

1. In <<SETUP MODE>> initial screen, press
.
ENTER
The <<SETUP MODE>> menu screen (Settings
or Paper Length Check) appears.
NOTE
The "Settings" screen does not appear and the
"Paper Length Check" screen first appears when
your scanner is not controlled through the video
or TP interface.
2. Press twice.
The <<SETUP MODE>> menu screen (Paper
Thickness Setup) appears.
3. Press
ENTER
The paper load prompting screen appears,
requesting adjustment paper.
4. Select thickest paper used for your jobs and put
the paper on the hopper.
5. Press
ENTER
The "Adjusting!!" message appears. The scanner
lifts the hopper, feeds the paper, and adjusts the
sensing level of the sensor, then saves its value.
After ejecting the sheet, the "Finished!!" message
appears for two seconds, then the LCD returns to
the <<SETUP MODE>> menu screen (Paper
Thickness Setup).
If an error (for example, Mis-pick) occurs during
adjustment, remove the paper and press
. The paper load prompting screen
CANCEL
appears again. Repeat steps 4 and 5.
6. Press
CANCEL
The LCD returns to the Ready screen.
6-12
.
.
two times.
<<SETUP MODE>>
<<SETUP MODE>>
Settings
<<SETUP MODE>>
Paper Length Check
<<SETUP MODE>>
Paper Thickness Setup
Paper Thickness Setup
Set the adjustment paper
Paper Thickness Setup
Adjusting!!
Paper Thickness Setup
Finished!!
<<SETUP MODE>>
Paper Thickness Setup
Ready