Light Bulbs - GE Monogram ZV1050 Owner's Manual

Light bulbs

NOTE: The glass cover should be removed only when
cool.
Before replacing the bulb, disconnect electrical
power to the hood at the main fuse or circuit
breaker or main power disconnect switch located
on the control housing. Allow bulbs to cool before
touching.
For safety, do not touch a hot bulb with bare hands
or a damp cloth.
To change the light bulbs:
1. Remove the lamp lens cover by inserting a small
flat-blade screwdriver into each of the three slots
and gently prying it free.
NOTE: Do not remove the outer trim ring (lamp
assembly).
2. Grasp the bulb and pull it straight out.
3. Using gloves or a dry cloth, remove the new bulb
from the packaging. (Wearing latex gloves may
offer a better grip.) The bulb must be the same
wattage, 120-volt, 25-watt halogen with a G-9
base. Early-life bulb failure may occur if wattage
is too high.
4. Push the bulb straight all the way into the
receptacle.
5. Replace the lens cover by inserting the three
retaining tabs into the slots and pressing into place.
NOTE: For improved lighting, clean the glass cover
frequently using a damp cloth. This should be done
when the hood is completely cool.
6. Reconnect electrical power to the hood.
NOTE: Order replacement 120-volt, 25-watt
halogen bulb with G-9 base, WB25X10020.
These bulbs can be ordered from your GE supplier.
On some models, the lights are located on the
sides, on the underside of the hood.
CAUTION:
Care and Cleaning
Stainless Steel Hood
On some models, the lights arelocated on the
front and back, on the underside of the hood.
Use a small flat-blade screwdriver
to remove the lamp lens cover.
Tab
NOTE: Make sure the tabs are
inserted into the slots.
ONLY use a new 120-volt, 25-watt
halogen bulb with a G-9 base.
Receptacle
Use gloves
or cloth
NOTE: Do not touch the new halogen bulb
with bare fingers. Skin oils can cause early-
life bulb failure.
Bulb
Outer trim ring
(lamp assembly)
Do not remove
Removable inner
lamp lens cover
7