To install the component:
Power down the server (on page 23).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 23).
3.
Remove the access panel (on page 25).
4.
If a full-length expansion board is installed in slot 1, release the full-length expansion board retainer,
5.
and then remove the primary PCIe riser cage.
If a full-length expansion board is installed in slot 4, release the full-length expansion board retainer,
6.
and then remove the secondary PCIe riser cage.
Remove the air baffle (on page 34).
7.
Hardware options installation 77