NordicTrack NTEL91211.0 User Manual page 10

8. Apply a small amount of grease to the axle on
the Left Pedal Arm (14).
Position the Left Handlebar Leg (12) as shown.
Then, insert the Left Pedal Arm (14) into the Left
Handlebar Leg.
Attach the Left Pedal Arm (14) with an M10 x
20mm Screw (61), a Pedal Axle Cover (39), and
an M10 Washer (64). Tip: Avoid damaging the
Pedal Axle Cover when tightening the Screw.
Attach the Right Pedal Arm (not shown) in
the same way.
9. Apply a small amount of grease to the axle on
the Left Pedal Arm Bracket (43).
Attach the left Pedal Leg (8) to the Left Pedal
Arm Bracket (43) with two M10 x 20mm Screws
(61) and two M10 Split Washers (79).
Attach the right Pedal Leg (8) in the same
way.
See step 5. Tighten the M10 x 20mm
Screws (61).
See step 4. Tighten the M8 x 13mm
Screws (62).
8
9
Grease
43
10
12
39
64
61
Grease
14
61
79
8
8