Rear Panel Connections - Datavideo SE-2800 Instruction Manual

Rear Panel Connections

1920x1080
HD-SDI
HD Inputs BNC
1, 5 & 9 Yes
2, 6 & 10 Yes
3, 7 & 11 Yes
4, 8 & 12 Yes
CVBS
SD Inputs
BNC
1, 5 & 9 Yes
2, 6 & 10 Yes
3, 7 & 11 ---
4, 8 & 12 ---
Video Input Modules
The SE-2800 can be supplied with eight or twelve video input
channels.
An SE-2800 with eight input channels has two video input modules
fitted. An SE-2800 with twelve input channels has three video input
HDMI
modules fitted. An eight channel unit can be upgraded to twelve
inputs by adding another Video Input Module.
---
There are four video input channels on each Video Input Module.
---
Each Video Input Module (shown top left) has the same
---
connections, four BNC connectors and one HDMI port. The fourth
BNC connector and the HDMI port are an option for the same input
Yes
channel.
SDI
The two tables, on the left, show which types of video inputs can be
HDMI
BNC
connected to the SE-2800 switcher. For example, only input
channels 4, 8 and 12 have the HDMI input option.
Yes ---
Yes ---
NOTE: The switcher cannot accept 1280x720 or 1440x1080 inputs
Yes ---
and has no input scaling options.
Yes Yes
SYNC I/O
The SE-2800 can be synchronised with other studio equipment such
as cameras and House sync. Input BNC (14) will accept House sync
or Tri-level sync. Output BNC (13) can be used to pass the sync
signal to other studio equipment such as cameras or recorders.
CONSOLE
This 9pin D-Sub connector (16) is used to connect the Control Panel
/ Keyboard to the rear of the SE-2800 Main Processing unit.
HDMI MULTIVIEW OUT
The SE-2800 has two HDMI outputs (17) which can be used to
display a preset combination of inputs plus program and preset. See
page 11 for the five preset multi-view options.
SDI VIDEO OUTPUTS
The three BNC output connectors (15) are user defined SDI outputs.
Each of these SDI outputs has the option to be:
SDI outputs 2 and 3 also have the option to be a Program output
which has been downscaled from HD to SD resolution.
ETHERNET PORT
This RJ45 Ethernet port (18) is used to connect the SE-2800 to a
PC for remote control, or to update the unit's firmware, or to
configure the switcher. See page 24 for more details.
1. Program output
2. Preview output
3. Program output without logo
4. Program output without logo and DSK subtitles
5. Aux output of a selected video input channel
9