Table of Contents
Advertisement
Figure 11
A B C D E F G H I J K L M
N O P R Q S T U V W X Y Z
a b c d e f g h i j k l m
n o p q r s t u v w x y z
– .
0 1 2 3 4 5 6 7 8 9
CLR POS END
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2.
Press the menu control UP, DOWN, LEFT, or RIGHT to select a character, then press (SETUP)
MENU to accept it. The character is saved and the title cursor at the bottom of the screen moves
to the next position. You can use the
make changes, and you can also select CLR to delete the entire title and start again.
3.
Repeat
step 2
until your camera title is complete.
4.
Select POS to position where you would like the camera title to be located on screen. Select the
position using the menu control, then press (SETUP) MENU to confirm the position.
5.
Select END when you are finished.
Sync Control/Line-Lock Setup
This screen allows you to synchronize the vertical interval sync pulse of your camera with other
equipment to reduce the effect of picture roll on the monitor. Line-Lock mode is only available when
using 24 VAC power.
Document 800-01529 Rev A
02/08
Adding Camera Title Screen
CAMERA ID
symbols to go back or forward in the title name to
23
Advertisement
Table of Contents
