3Com SuperStack 4 Configuration Manual page 326

338 C 12: F S
HAPTER ILE
Sending the Information
to SNMP Network
Management
M
YSTEM ANAGEMENT
When defining the information sent to the trap buffer,
channel-name
direction.
Every channel has been set with a default record, whose module name is
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there
is no specific configuration record for a module in the channel, use the default
one.
If you want to view the debugging information of some modules on the Switch,
you must select
source, meantime using the
Switch of those modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in System View.
Table 408 Configuring the Output Format of Time-stamp
Operation
Configure the output format of
the time-stamp
Output time-stamp is disabled
To send information to SNMP NM, follow the steps below:
1 Enabling info-center
Perform the following operation in System View.
Table 409 Enabling/Disabling Info-center
Operation
Enable info-center
Disable info-center
Info-center is enabled by default. After info-center is enabled, system
performances are affected when the system processes much information because
of information classification and outputting.
2 Configuring to output information to SNMP NM
Perform the following operation in System View.
Table 410 Configuring to Output Information to SNMP NM
Operation
Output information to SNMP NM
Cancel the configuration of outputting
information to SNMP NM
3 Configuring the information source on the Switch.
must be set to the channel that corresponds to the Console
as the information type when configuring information
debugging
debugging
Command
info-center timestamp { log | trap |
debugging } { boot | date | none }
undo info-center timestamp { log | trap |
debugging }
Command
info-center enable
undo info-center enable
channel-number
command to turn on the debugging
Command
info-center snmp channel {
channel-number channel-name
|
undo info-center snmp channel
or
default
}