Tension Adjustment Of The Door Spring; Connection Of Drain Hoses - Baumatic BDW47 Instruction Manual

Tension adjustment of the door spring

●
The door springs are set at the factory to the proper tension for the outer door. If aesthetic
wooden panel are installed, you will have to a djust the door spring tension. Rotate the adjusting
screw to drive the adjustor to strain or relax the steel cable(see figure 5).
Do or spring te nsion is correct w hen
the door remains horizontal in the
fully opened position，yet rises
to a c lose with the sligh t lift of a
finger.

Connection of drain hoses

●
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it
run into the sink, making sure to avoid bending or crimping it. Use the speical
plastic support that comes with the appliance (figure 6). The free and of the hose
must be at a height between 400 and 1000mm and must not be immersed in water
to avoid the back flow of it.ATTENTION: The special plastic hose support must be
solidly fastene d to the wall to prevent the drain hose from moving and allowing water
to spill outside the drain.
【Figure6】
Close the drain hose hook to the counter
【Figure5】
Tension adjustment
of the door spring
PLEASE HANG UP THE DRAIN HOSE EIT HER WAY OF A, B, C
Front
Drain pipe
relax
Drain hose hook
A
B
C
φ 40mm
21
Counter