Dishwasher Installation Steps - Baumatic BDW47 Instruction Manual

Dishwasher installation steps

●
Install the furniture door to the outer door of the dishwasher using the brackets provided. Refer
1
to the template for positioning of the brackets.
Adjust the tension of the door springs by using an Allen key turning in a clockwise motion to
2
tighten the left and right door springs. Failure to do this could cause damage to your dishwasher
(Illustration 2) .
Connect the inlet hose to the cold water supply
3
Connect the drain hose. Refer to diagram (Figure 7)
4
Connect the power cord
5
Put the dishwasher to slide rails(Illustration4)
6
Affix the condensation strip under the work surface of cabinet. Please ensure the condensation
7
strip is flush with edge of work surface.
Place the dishwasher into position.
8
Level the dishwasher. The rear feet can be adjusted from the front of the dishwasher by turning
9
the screws on the left and right hand side of the cabinet (Illustration 6A). To adjust the front feet,
use a wrench and turn the front feet until the dishwasher is level (Illustration 6B).
The dishwasher must be secured in place. There are two ways to do this:
10
A. Normal work surface-secure to the work surface by using two woodscrews ensuring the
dishwasher weight is not being hit by the surface (Illustration 7).
B. Marble or granite work top-secure the bracket to the side panel of the dishwasher and secure
the dishwasher to the furniture housing. Put the rubber cap over the screw ( Illustration 8).
SCREW
CONE G EAR
6A
.
.
6B
6
【Figure 7】
.
.
5
4
RUBBER
8
SCREW
22
2
7
COVER