Troubleshooting Guide - Razor PowerRider 360 Owner's Manual

TROUBLESHOOTING GUIDE

Problem
Product does not run.
Product was running but
suddenly stopped.
Short run time.
Product runs sluggishly.
Sometimes the product doesn't
run, but other times it does.
Product makes loud noises or
grinding sounds.
Need Help? Visit our web site for replacement parts and product support at www.razor.com or call toll-free at
866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time. Please have the product I.D. code (located on the white
label on your product or back of charger) available for better assistance.
Possible Cause
Undercharged battery.
Charger is not working.
Loose wires or connectors.
Undercharged battery.
Battery is old and will not accept full
charge.
Riding conditions are too stressful.
Product is overloaded.
Loose wires or connectors.
Motor or electrical switch damage.
Chain is too dry.
Solution
Charge the battery. A new battery should have been charged for at least
12 hours before using the product for the first time and up to 12 hours after
each subsequent use.
Check all connectors. Make sure the charger connector is tightly plugged
into the charging port and that the charger is plugged into a functioning
wall outlet.
Contact Razor Customer Service to get replacement charger.
Check all wires and connectors to make sure they are tight.
Charge the battery. A new battery should have been charged for at least
12 hours before using the product for the first time and up to 12 hours after
each subsequent use.
Even with proper care, a rechargeable battery does not last forever.
Average battery life is 1 to 2 years depending on product use and
conditions. Replace only with a Razor replacement battery.
Use only on solid, flat, clean and dry surfaces, such as pavement or level
ground.
Make sure you do not overload the product by allowing more than one
rider at one time, exceeding the maximum weight limit, going up too steep
a hill, or towing objects behind the product. Check the air pressure of the
front wheel.
Check all wires connectors to make sure they are tight.
Contact your local Razor authorized service center for diagnosis and repair.
Contact Razor customer service or visit www.razor.com.
Apply a lubricant, such as 3 in 1
12
or Tri-Flow ,to the chain.
™ ™