Adjusting The Brake - Razor PowerRider 360 Owner's Manual

REPAIR AND MAINTENANCE
q Adjusting the Brake
Required Tools: Phillips screwdriver, 10 mm wrench
1
To adjust the brake cable
tension, thread the brake lever
adjuster in or out 1/4 to 1/2 turn
until the desired brake adjustment
in attained. Most adjustments are
complete at this step. If the brake
still needs further adjustment,
proceed to the following steps.
4
If the brake is too tight or too
loose, use a 10 mm wrench to
loosen the nut on the brake cable
for additional adjustment. Securely
tighten the nut when finished.
Need Help? Visit our web site for replacement parts and product support at www.razor.com or call toll-free at
866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time. Please have the product I.D. code (located on the white
label on your product or back of charger) available for better assistance.
2
Using a Phillips screwdriver,
loosen the two (2) screws on the
foot pegs.
5
Replace the motor cover/
chain guard. Refer to steps 2
and 3 above.
3
Using a Phillips screwdriver,
loosen the six (6) screws to remove
the motor cover/chain guard.
10