White Balance Adjustments; Horizontal & Vertical Position Adjustments - Mitsubishi Electric WD-52327 Service Manual

[Video Circuit]
3. White Balance
Measuring
Instrument
Test Point
Ext. Trigger ------
Measuring
------
Range
Input Signal
White Raster
Input Terminal
Video Input
CIRCUIT ADJUST MODE
Activate ........ MEN U-5-7-5-7
Function ... ......... .....AUD IO
Item No. ...... ...........VIDEO
Adjus t Data ...........AD JU ST
Save Data .... ......... ENTER
Exit ......... .....MEN U (twice)
[PICTURE POSITION]
4. Horizontal/Vertical Position
Measuring
----
Instrument
----
Test Point
Ext. Trigger
------
Measuring
-------
Range
Input Signal
Internal Pattern "B"
Input Terminal
External Input
MODEL: WD-52327 / WD-62327
Purpose:
To set high, mid and low temperature white levels.
Symptom:
White areas have a color tint.
1. Supply a 100% white raster to an External Video Input.
3. Activate the Service Mode. (MENU-5-7-5-7)
4. Select the "DDP" function. (AUDIO button)
5. Select adjustment Items with the VIDEO button.
NOTE: Data is displayed in the hexadecimal format.
6. Adjust the data for Items "120 GGH", "121 GRH and "122 GBH" for optimum
white at the center of the screen.
7. Adjust the data for Items "123 GGM", "124 GRM and "125 GBM" for optimum
white at the center of the screen.
8. Adjust the data for Items "126 GGL", "127 GRL and "128 GBL" for optimum
white at the center of the screen.
9. Press "ENTER" to save data changes.
10. Press "MENU" twice to exit the Service Mode.
Purpose:
To center picture on the screen.
Symptom:
Picture is off center.
NOTE: The TV must be on a flat level surface.
1. Select an External Input with no signal.
2. Press "MENU-5-7-5-7" in sequence (activates the Service Mode).
3. Press "AUDIO" to select the "FPGA" function.
4. Press "2" to activate internal Test Pattern B. (Shown below)
5. Use the "VIDEO" button to select Item "1 H-DLY".
6. Use the "ADJUST" buttons to center the picture Horizontally..
7. Press "ENTER" to save the adjustment.
8. Use the "VIDEO" button to select Item "2 V-DLY".
9. Use the "ADJUST" buttons to center the picture Vertically.
10. Press "ENTER" to save the adjustment.
11. Press "9" to terminate the test pattern.
12. Press "Menu" twice to terminate the Adjustment Mode.
Page 28
CIRCUIT ADJUST MODE
Activate ........ MENU-5-7-5-7
Function .................AUDIO
Item No. .................VIDEO
Adjust Data ...........ADJUST
Save Data .... .........ENTER
Exit .............."9" then "MENU"