Removing Dmd Heat Sensor; Removing Bottom Plate & Black Support Bracket - Mitsubishi Electric WD-52327 Service Manual

Remove the follolwing parts from the Optical Engine
• DMD Thermal Sensor
• The Optical Engine bottom plate and black bracket
DMD Termal Sensor Removal (Figure 1)
1) Remove screw (a) on the top of the DMD Fan.
2) Set the Thermal Sensor aside to install on the replacement Optical Engine.
Bottom Plate & Black Bracket Removal
1) Remove the 4 screws (B) from the Bottom Plate (Figure 2)
2) Remove the two screws (c), holding the Black Bracket to the Lamp Cartridge Housing. (Figure 3)
MODEL: WD-52327 / WD-62327
Figure 1: DMD Thermal Sensor
Bottom View
Figure 2: Bottom Plate
Page 15
(a)
Thermal Sensor
Heat Sensor
Bottom Plate
(B)