Removing/Installing The Batteries On Zoom 400; Removing; Installing - Invacare HMV Zoom 300 Service Manual

SECTION 12—BATTERIES AND CHARGER

Removing/Installing the Batteries on Zoom 400

NOTE: For this procedure, refer to FIGURE 12.3.

Removing

1. Place the powered scooter in a well ventilated area.
Work should be performed in an area without risking damage to carpeting or floor
covering.
2. Turn power off and remove the key from the ignition.
3. Remove the seat. Refer to Removing/Installing the Seat on page 34.
4. Remove the rear shroud. Refer to Removing/Installing the Rear Shroud on page 44.
5. Disconnect the two (2) BLACK battery connectors from the wiring harness connectors
(Detail "C" of FIGURE 12.3).
6. Pull the hook and loop fastening battery strap apart.
7. Perform one (1) of the following to remove the battery from the battery tray
(Detail "D" of FIGURE 12.3):
• Batteries with Built-in Lifting Strap - Use built in lifting strap to remove the battery
from the battery tray (Detail "B" of FIGURE 12.3).
• Batteries without Built-in Lifting Strap - Use a battery lifting strap to remove the
battery from the battery tray (Detail "A" of FIGURE 12.3).
8. Disconnect the battery cable. Refer to Connecting/Disconnecting the Battery Cables on
the Zoom 400 on page 90.

Installing

1. Connect the battery cable. Refer to Connecting/Disconnecting the Battery Cables on
the Zoom 400 on page 90.
2. Place the powered scooter in a well ventilated area where work can be performed
without risking damage to carpeting or floor covering.
3. Turn power OFF and remove the key from the ignition.
4. Remove the seat. Refer to Removing/Installing the Seat on page 34.
5. Remove the rear shroud. Refer to Removing/Installing the Rear Shroud on page 44.
6. Perform one (1) of the following to position the battery into the battery tray
(Detail "D" of FIGURE 12.3):
• Batteries with Built-in Lifting Strap - Use built in lifting strap to position battery
onto the battery tray (Detail "B" of FIGURE 12.3).
• Batteries without Built-in Lifting Strap - Use a battery lifting strap to position
battery onto battery tray. When battery is in proper position, remove lifting strap
(Detail "A" of FIGURE 12.3).
7. Connect the two (2) BLACK battery connectors to the wiring harness connectors
(Detail "C" of FIGURE 12.3).
Zoom 300 and Zoom 400
CAUTION
88
Part No 1122167