Removing/Installing The Batteries On 400; Removing; Installing - Invacare HMV 300 Owner's Operator And Maintenance Manual

Highly maneuverable vehicle
Table of Contents

Advertisement

REMOVING/INSTALLING THE BATTERIES ON
400
NOTE: For this procedure, refer to FIGURE 12.2.

REMOVING

1. Place the powered scooter in a well ventilated area where work can be performed
without risking damage to carpeting or floor covering.
2. Turn power OFF and remove the key from the ignition.
3. Remove the seat. Refer to Removing/Installing the Seat on page 34.
4. Remove the rear shroud. Refer to Removing/Installing the Rear Shroud on page 44.
5. Disconnect the two (2) Black battery connectors from the wiring harness connectors.
6. Pull the hook and loop fastening battery strap apart.
7. Perform one (1) of the following to remove the battery from the battery tray:
A. BATTERIES WITH BUILT-IN LIFTING STRAP - Use built in lifting strap to remove
the battery from the battery tray.
B. BATTERIES WITHOUT BUILT-IN LIFTING STRAP - Use a battery lifting strap to
remove the battery from the battery tray.

INSTALLING

1. Place the powered scooter in a well ventilated area where work can be performed
without risking damage to carpeting or floor covering.
2. Turn power OFF and remove the key from the ignition.
3. Remove the seat. Refer to Removing/Installing the Seat on page 34.
4. Remove the rear shroud. Refer to Removing/Installing the Rear Shroud on page 44.
5. Perform one (1) of the following to position the battery into the battery tray:
A. BATTERIES WITH BUILT-IN LIFTING STRAP - Use built in lifting strap to
position battery onto the battery tray.
B. BATTERIES WITHOUT BUILT-IN LIFTING STRAP - Use a battery lifting strap to
position battery onto battery tray. When battery is in proper position, remove
lifting strap.
6. Connect the two (2) BLACK battery connectors to the wiring harness connectors.
7. Secure batteries in the battery tray using the battery strap.
8. Reinstall the rear shroud. Refer to Removing/Installing the Rear Shroud on page 44.
9. Reinstall the seat. Refer to Removing/Installing the Seat on page 34.
NOTE: New batteries MUST be fully charged BEFORE using, otherwise the life of the batteries
will be reduced.
10. If necessary, charge the batteries. Refer to Charging the Batteries on page 58.
Part No. 1118395
Download from Www.Somanuals.com. All Manuals Search And Download.
SECTION 12—BATTERIES
53
300 and 400

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hmv 400

Table of Contents