Adjusting Downward Travel Of Abrasive Wheel; Wrench Storage - Delta 20-140 Instruction Manual

ADJUSTING
DOWNWARD TRAVEL
OF ABRASIVE WHEEL
A stop screw (A) Fig. 14, is provided to limit the down-
ward travel of the abrasive wheel. This adjustment is
made by loosening lock nut (B) and turning stop screw
(A) in or out as desired. Then tighten lock nut (B).
Fig. 15 illustrates edge of the arm casting (C) contacting
stop screw (A), limiting the downward travel of the
abrasive wheel. NOTE: As the abrasive wheel becomes
smaller in diameter (because of wear), the downward
travel of the wheel can be increased.

WRENCH STORAGE

A built-in clamp (A) Fig. 16, is provided on the back edge
of the machine base for convenient storage of the
adjusting wrench (B), which is supplied with your
machine.
Fig. 17 illustrates the wrench (B) stored in position inside
the clamp.
A
B
A
B
9
Fig. 14
C
A
Fig. 15
B
Fig. 16
Fig. 17