Adjusting Downward Travel Of Abrasive Wheel; Carrying Handle - Delta 20-142C Instruction Manual

Figure 10
This view illustrates a typical angle cutting
operation.
Adjusting Downward Travel
Of Abrasive Wheel
Figure 11
A stop screw (A) is provided to limit the down-
ward travel of the abrasive wheel. This adjust-
ment is made by loosening lock nut (B) and
turning stop screw in or out as needed. Then
tighten lock nut
Figure 12
This view illustrates the stop plate (A) contact-
ing stop screw (B).
NOTE: As the diameter of the abrasive wheel
decreases (due to wear), the downward travel
can be increased.

Carrying Handle

Figure 13
A carrying handle (A) is provided for ease of
transportation. When transporting the machine,
the cutting head should be locked in the down
position using the holddown chain (B).
9
Fig. 10
Fig. 11
Fig. 12
Fig. 13