Vise; Angle Cutting - Delta 20-140 Instruction Manual

VISE

Clamping the workpiece can be accomplished quickly
and easily as follows:
1. Lift half-nut (A) Fig.10, off screw (B).
2. Pull out screw handle (C) Fig.10, far enough to allow
workpiece (D) to be placed in vise opening against rear
vise clamp (E) as shown. NOTE: It is not necessary to
thread screw handle (C) when the half-nut (A) is in the
raised position. The screw handle (C) can be rapidly
pulled out or pushed in.
3. Push in on screw handle (C) Fig. 11, until front vise
clamp (F) contacts workpiece (D).
4. Flip half-nut (A) Fig. 11, over to engage screw (B)
and tighten screw handle (C) to securely clamp work-
piece (D) in the vise.

ANGLE CUTTING

1. Loosen two screws (G) Fig. 12, and rotate rear vise
clamp (H) to the desired angle. Then tighten the two
screws (G). The front vise clamp (F) pivots on its post
and will automatically align itself with the workpiece.
2. Fig. 13, illustrates a workpiece clamped in the vise
for a typical angle cutting operation.
D
8
E
B
A
C
Fig. 10
D
F
A
B
C
Fig. 11
H
F
G
Fig. 12
Fig. 13