Asio Direct Monitor Send/Return - E-Mu 1616 PCI Owner's Manual

Choose one of the Send Outputs. Click on a destination to select it.
3.
Choose one of the Return Inputs. Click on a source to select it.
4.
Click OK to select the Send and Return, or Cancel to cancel the operation.
5.

ASIO Direct Monitor Send/Return

This type of insert send breaks the signal at the insert point and sends it out to the
selected ASIO Host Input destination (such as Cubase or Sonar). A return source signal
is also selected which returns the signal to the channel strip from an ASIO Host Output.
The ASIO Direct Monitor Send/Return is unique in that it utilizes ASIO 2.0 zero-latency
monitoring. In order to utilize this feature, Direct Monitoring must be enabled in the
audio recording application.
While recording, the Direct Monitor Send/Return routes the signal to the recording
application, but monitors directly from the input to eliminate latency. During playback,
the recording application automatically switches the Direct Monitor Send/Return to
monitor the recorded track.
The Direct Monitor Send/Return also allows the recording application to control
volume and pan. Normally when using direct monitor recording you'll want to control
the volume and pan from the recording application. In this case, set the PatchMix DSP
stereo pan controls hard left and right, mono pan controls to center, and the fader to
0dB.
E-MU PCI Digital Audio System
Input
Insert
Send/Return
Panning
Fader
Aux 1 Bus
Aux 2 Bus
Main Output Bus
Input
Direct Mon Recording
Software
Recording
4 - The PatchMix DSP Mixer
destination you want to
use is not available in the
To Physical Output
list, they are probably
From Physical Input
already being used
elsewhere. Check the
input Strips, Inserts and
Output Assignments.
Input
Direct Mon Recording
Software
Playback
Mixer Strip Creation
If the source or
39