Homelite UT10927A Operator's Manual page 12

STARTING A COLD ENGINE:
3. Move the chain brake to the BRAKE position.
Note: Set the chain brake by pushing the chain brake
lever/hand guard forward (towards the bar), to the
brake position. Refer to "Operation – Operating Chain
Brake" for additional information.
4. Set the ignition switch to the RUN (I) position.
5. Fully press and release the PRIMER BULB 7 times.
6. Pull CHOKE lever all the way OUT to full position. The
partial throttle position is automaticaaly set when the
choke lever is set at full choke.
CHOKE LEVER
OPERATION
Fig. 14
STARTER
GRIP
Fig. 15
Page 12
CHOKE LEVER
TRIGGER
RELEASE
THROTTLE TRIGGER
Fig. 16
STARTER
GRIP
Fig. 17
RUN POSITION
Fig. 18