Telnet Interface; Figure 4-45. Starting Telnet Session - Comtech EF Data MR-S2 Installation And Operation Manual

Digicast Media Router S2 Receiver CMR-5975 (MR-S2)
Device Management via User Interfaces
4.4

Telnet Interface

Telnet provides a textual interface over a LAN. Most PCs have the capability to use Telnet. To
use Telnet on a Microsoft Windows
The Run dialog box is shown in Figure 4-45. In the
xxx.xxx.xxx.xxx," where xxx.xxx.xxx.xxx is the IP address of the MR-S2. If the port number
has been modified from the
appended with a colon to the IP address.
The user will be prompted to enter the user name and password to gain access to the telnet
interface.
NOTE
Once the menu is started, press
4-46. Main Menu . The user may navigate the menus in the same manner as the Terminal
Interface. With specific exceptions as noted in the Terminal Interface section, the menus available
via Telnet and Serial interfaces are identical.
®
product, click
via the Terminal Interface, then the port number must be
standard 23

Figure 4-45. Starting Telnet Session

The default username is "comtech" and the default password is
"comtech", both of which are case sensitive.
<ENTER>
, then
text window, enter "telnet
Open:
and the MR-S2 Main Menu will display as shown in
4-54
Revision 1
MN-0000032
.