Management Blade Settings - Fujitsu PRIMERGY BX900 S1 Service Supplement Manual

5

Management Blade Settings

V
CAUTION!
Blease observe the safety notes on
Figure 29: Management Blade DIP switch(1)
The server blade is delivered with the DIP switches set in the following positions:
Switch Function
1 Flash Swap - activates the second management blade boot ROM.
The second boot ROM can be used as reserve, if a management
blade firmware update has failed.
2 Recovery Mode - firmware update
3 Default Set - loads the standard management blade cofiguration (IP
address, password, ...)
4 Clear Password - clear user defined password
5 Diagnostic Mode - activates the diagnostic mode
6 Not defined
BX900 S1
page
Service Supplement
11ff.
Default
OFF
OFF
OFF
OFF
OFF
OFF
43