Fujitsu D3049 Technical Manual page 34

Features
LAN connectors
The system board is equipped with a Gigabit Ethernet Controller of the type
®
Intel 82574L and 82579LM. The LAN controller supports transmission rates of
10 Mbit/s, 100 Mbit/s and 1 Gbit/s.
The LAN controller (only for Shared LAN) also supports WOL functionality by
means of Magic Packet™. It is also possible to start a system via a LAN without
a separate boot hard disk drive. PXE is supported here.
The separate management LAN connector is used as a management interface
(iRMC S3) and is prepared for operation with the Remote Management.
Optionally LAN connector 2 (center) can also be used for iRMC S3 server
management.
Each LAN connector has two LEDs which display the speed of the connection
and its status:
Figure 8: LAN LEDs
No. Indicator
1 LAN
link/transfer
2 LAN speed
34
Description
Steady green signal when a LAN connection exists.
Remains dark when no LAN connection exists.
Flashes green when LAN transfer takes place.
Steady yellow signal (without Management LAN) in the
event of a LAN transfer rate of 1 Gbit/s
Steady green signal in the event of a LAN transfer rate
of 100 Mbit/s.
Remains dark in the event of a LAN transfer rate of
10 Mbit/s.
Technical Manual TX140 S1 / TX120 S3