Advertisement
Lighting the heater
1. Turn on the gas at the gas bottle tap.
2. FROM «
» POSITION, fully depress the control knob for 10 seconds and turn to
(Small Flame) position. (If pilot flame does not ignite return to starting position and
repeat). Continue to fully depress the knob for a further 20 seconds to allow the thermo-
couple probe to heat up. Then turn the knob to select the desired setting as follows:
(Small Flame) Low Input
(Big Flame) Maximum Input
Auxiliary ignition
Should piezoelectric starter fail to work, repeat operation on control knob and use a match
to light pilot flame and repeat the operations above described.
Tunring off the heater
Turn off the gas bottle tap.
The Heater will be totally "OFF" only if the tap at the gas bottle is turned off.
Electrical connection
-
Before using the appliance check that your supply voltage is the same as that shown on
the rating label of the unit.
-
Connect your heater to earth provided socket only, having a capacity of at least 10/16 A.
-
THIS APPLIANCE CONFORMS TO DIRECTIVE EN 55014 GOVERNING RADIO
INTERFERENCE.
Operation and use
Fully insert plug into socket-outlet and switch on the fan heater following the instructions
of Fig. 7.
Before switching on the gas burner, read carefully the relevant operating instructions.
VENTILATION
ONLY
(It can be used
together with the gas
burners for an ade-
quate heat distribu-
tion).
OPERATING INSTRUCTIONS
VENTILATED RADIANT HEATER
VENTILATION + 1000 W
HEATING RIGHT OR LEFT
OFF
(It can be used together with
the gas burners - 4200 W -
for the fast heating of the
room).
(Medium Flame) Medium Input,
VENTILATION
+ 2000 W
HEATING
(It can be used
together with the
gas burners - 4200
W - for the very fast
heating
room).
Fig. 7
of
the
5
Advertisement
