Dell PowerEdge C6145 Hardware Owner's Manual page 94

Token Setup Option
00C0 Remote Access
00CA CS Sparing Enabled
00CB CS Sparing Enabled
00D7 Serial port number
00D8 Load Optimal Default
0135 OnChip SATA Channel
0137 OnChip SATA type
0138 OnChip SATA type
0139 OnChip SATA type
013B OnChip SATA Channel
0173 Hardware Prefetcher
0174 Hardware Prefetcher
01C4 ACPI SRAT Table
01C5 ACPI SRAT Table
021F Power Management
0221 Power Management
0222 Power Management
0224 Onboard VGA device
0225 Onboard VGA device
0231 CPU DownCore Mode
0232 CPU DownCore Mode
024D Wait For 'F1' If Error
024E Wait For 'F1' If Error
024F Quiet Boot
0250 Quiet Boot
94 | Using the System Setup Program
Description
Serial Console Redirection On, output to
COM1. See also token D7h.
Disable Redundant memory.
Enable Redundant memory.
Console redirection to COM2.
Load Optimal Default.
Disable Onboard SATA controller(s).
Onboard SATA controller(s) is set to Native
IDE mode.
Onboard SATA controller(s) is set to AHCI
mode.
Onboard SATA controller(s) is set to RAID
mode
Enable Onboard SATA controller(s).
Disable CPU HW Prefetcher.
Enable CPU HW Prefetcher.
Disable for ACPI SRAT Table.
Enable for ACPI SRAT Table.
This will set max. performance.
Allow OS to control p-state.
Enable APML control.
Enable onboard VGA chip.
Disable onboard VGA chip, the BMC
remote KVM function can not work.
Enable CPU 4 cores only.
Enable CPU 2 cores only.
Enable the BIOS from prompting for F1/F2
on error. BIOS pauses at F1/F2 prompt.
Disable the BIOS from prompting for F1/F2
on error. BIOS pauses at F1/F2 prompt.
Enable the display of the splash or summary
screen, rather than the detail of the POST
flow.
Disable the display of the splash or