Removing The 10Gbe Mezzanine Card - Dell PowerEdge C6145 Hardware Owner's Manual

Item Cable
SAS/SGPIO
cable
SAS cable
SAS cable
SGPIO cable

Removing the 10GbE Mezzanine Card

CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
1 Recommend to turn off the system, including any attached peripherals,
and disconnect the system from its electrical outlet.
2 Remove the system-board assembly. See "Removing a System-Board
Assembly" on page 115.
3 Disconnect all the cables from the 10GbE mezzanine card.
4 Remove the three screws that secure the 10GbE mezzanine-card
assembly. See Figure 3-26.
5 Lift the 10GbE mezzanine-card assembly away from the mezzanine-
card bridge board on the system board. See Figure 3-26.
From
(SAS Mezzanine Card)
SAS_ports 0~3
SAS_port 4
SAS_port 5
SGPIO B
To
(HDD to Backplane
SATAII Connectors)
SATAII connectors
1~4 and SGPIO A
SATAII connector 5
SATAII connector 6
SGPIO B
Installing System Components | 155