Dell PowerConnect W-AirWave 7.6 Configuration Manual page 42

Field
RF Optimization
Profile
Event Thresholds
Profile
Wired AP Profile
Ethernet Interface 0
Link Profile
Ethernet Interface 1
Link Profile
AP System Profile
36 | Configuration Reference
Default Description
nchannel too high
l
nchannel too low
l
Select the pencil icon next to this field to edit or create additional profile settings
in the RF > 802.11a/g Radio page of Dell PowerConnect W Configuration.
Enables or disables load balancing based on a user-defined number of clients or
degree of AP utilization on an AP. Use this profile to detect coverage holes, radio
interference and STA association failures and configure Received signal strength
default
indication (RSSI) metrics.
Select the pencil icon next to this field to display the Profiles > RF section and edit
these settings as desired.
Defines error event conditions, based on a customizable percentage of low-speed
frames, non-unicast frames, or fragmented, retry or error frames. The drop-down
menu displays these options:
default
l
default
all additional RF profiles currently configured in Dell PowerConnect W
l
Configuration
Select the pencil icon next to this field to display the Profiles > RF > Events
Threshold section and edit these settings as desired.
Controls whether 802.11 frames are tunneled to the controller using Generic
Routing Encapsulation (GRE) tunnels, bridged into the local Ethernet LAN (for
remote APs), or a configured for combination of the two (split-mode). This profile
also configures the switching mode characteristics for the port, and sets the port
default
as either trusted or untrusted.
Select the pencil icon next to this field to display the Profiles > AP > Wired page
and adjust these settings as desired.
Sets the duplex mode and speed of AP's Ethernet link for ethernet interface 0. The
configurable speed is dependent on the port type, and you can define a separate
Ethernet Interface profile for each Ethernet link.
default
Select the pencil icon next to this field to display the Profiles > AP > Ethernet Link
details page and adjust these settings as desired.
Sets the duplex mode and speed of AP's Ethernet link for ethernet interface 1. The
configurable speed is dependent on the port type, and you can define a separate
Ethernet Interface profile for each Ethernet link.
default
Select the pencil icon next to this field to display the Profiles > AP > Ethernet Link
details page and adjust these settings as desired.
Defines administrative options for the controller, including the IP addresses of the
local, backup, and master controllers, Real-time Locating Systems (RTLS) server
values and the number of consecutive missed heartbeats on a GRE tunnel before
an AP reboots traps.
This field is a drop-down menu with the following options:
Non-integer RTLS Server Station Message Frequency
default
l
Too-high RTLS Server Port
l
Too-low AeroScout RTLS Server Port
l
Too-low RTLS Server Port
l
Select the pencil icon next to this field to display the Profiles > AP > System
details page and adjust these settings as desired.
Dell PowerConnect W-AirWave 7.6 | Configuration Guide