Table of Contents
Advertisement
1.
lamp
(➝ "How to Turn On/Off the Power" page 20)
2.
button
This button turns the power on or off.
(➝ "How to Turn On/Off the Power" page 20)
3.
Speaker
This speaker outputs the monitor audio.
Output from the speaker is disabled when headphones
are connected.
4.
PHONES/LEVEL
Headphone jack:
This jack is for connecting stereo headphones to listen to
the sound being recorded or played back with the head-
phones.
Monitor audio volume adjustment knob:
This knob adjusts the monitor audio volume of the head-
phones or speaker.
Set whether or not to link the MON L/R output jacks in the
"MONITOR OUT VOL." (➝ page 95) menu item.
5.
USB HOST port (USB 3.0 Type A)
(➝ "Connecting an External Device via the USB HOST
Port" page 47)
Note:
• Use a double-shielded cable to connect to this port.
• Use a USB 3.0 compliant cable to connect USB 3.0 compat-
ible storage devices.
16
Control Reference Guide: Slots and Other Parts
Slots and Other Parts
1
3 2 6
7
4
5
8
9
10
11
10
11
6.
P2 memory card access lamps
(➝ "P2 Card Access Lamp and P2 Card Status" page 22)
7.
P2 memory card slots
(➝ "P2 Cards" page 22)
8.
EJECT buttons
(➝ "P2 Cards" page 22)
9.
SD/SDHC/SDXC memory card slot and access lamp
Insert an SD/SDHC/SDXC memory card.
Insert the card cut-corner-edge first and label-side up, un-
til the card latches into place.
To remove it, check that the access lamp is not lit green or
flashing orange, then release the latch by gently pushing
the card in again.
Note:
Use an SD/SDHC/SDXC memory card for reading the CPS pass-
word, reading and writing menu settings, reading and writing
metadata, proxy recording, and AVCHD playback.
(➝ "Using SD/SDHC/SDXC Memory Cards" page 25)
10.
microP2 memory card access lamps
(➝ "P2 Card Access Lamp and P2 Card Status" page 22)
11.
microP2 memory card slots
(➝ "P2 Cards" page 22)
Advertisement
Table of Contents
