Sony DSC-W530 Service Manual page 23

Assembly-1: Installation Method of Battery Terminal Board
Remove the battery terminal board by
bending the claw of rock portion.
When assembling the battery terminal board,
replace it with new one because battery ]
terminal board will be bent.
Insert the battery terminal board into a slit in
BT holder to install.
* Battery terminal board is attached with
notch for installation.
Notch
Battery terminal
board
Battery terminal board
Fold the notch 3 or 4 times repeatedly to break.
Notch
Remove the notch.
Battery terminal board
Notch
DSC-W530_L2
Assembly-2: Insulating Sheet (670) Putting Position
Insulating Sheet (670)
SY-285 Board
Insulating Sheet (670)
Assembly-3: Precaution During of MA-473 Flexible Board
Installation.
Route the speaker harness and microphone
harness as shown below.
Microphone
Harness
MA-473 Flexible
Board
Tape SP
Speaker
Harness
Microphone
Harness
MA-473 Flexible
Board
3. ASSEMBLY
Assembly-4: Precaution During of Cabinet (Rear) Assy
Installation.
Align the slide switch at the camera mode,
when install cabinet (rear) assy.
Slide Switch
3-1E
Assembly-5: Attaching Method of LCD Cushion (700),
LCD Window (670)
Apply LCD cushion (700).
And hav e the Tab of the Release Paper and peel it off.
LCD Cushion (700)
Cabinet (Rear) Assy
LCD
Attach Cabinet (Rear) Assy to set.
Cabinet (Rear) Assy
Mike Lid (700)
Fit LCD Window (670) into the flame of
Cabinet (Rear) Assy and attach it on LCD Cushion (700).
LCD Window (670)
LCD Cushion (700)
Rear Cabinet Assy
Blow the air before attaching.
Be sure to keep away from dust.
Align corner of
LCD cushion (700)
with corner of LCD.
Release Paper
Tab