Transfer Width Exponent - Seagate Ultra160 Product Manual

SCSI Interface Product Manual, Rev. B
For DT synchronous transfers the REQ/ACK offset is the number of REQ transitions that may be sent by the
SCSI target port in advance of the number of ACK transitions received from the SCSI initiator port. For paced
transfers in DT DATA IN phase the REQ/ACK offset is the number of data valid state REQ assertions that may
be sent by the SCSI target port in advance of ACK assertions received from the SCSI initiator port.
For paced transfers in DT DATA OUT phase the REQ/ACK offset is the number of REQ assertions that may be
sent by the SCSI target port in advance of the number of data valid state ACK assertions received from the
SCSI initiator port.
See Section 2.9 for an explanation of the differences between ST and DT data transfers.
The REQ/ACK OFFSET value is chosen to prevent overflow conditions in the port's receive buffer and offset
counter. The REQ/ACK OFFSET values and which timing values shall be selected are defined in Table 7.
Table 15.
Value Description
00h Specifies asynchronous transfer agreement.
01h - FEh Synchronous or paced transfers with specified offset. Determined by transfer period factor (see Table 13).
FFh Synchronous or paced transfers with unlimited offset. Determined by transfer period factor (see Table 13).
Table 19 defines valid combinations of REQ/ACK OFFSET and other fields.
2.12.7

Transfer width exponent

The TRANSFER WIDTH EXPONENT field defines the transfer width to be used during DATA IN and DATA
OUT phases. The values are defined in Table 16.
If any of the protocol options bits other than QAS_REQ are set to one, then only wide transfer agreements are
valid. If all the protocol options bits other than QAS_REQ are set to zero, wide transfer agreements and narrow
transfer agreements are valid.
Table 16: Transfer width exponent
Value Description
00h Specifies 8-bit data bus (i.e., narrow transfer agreement)
01h Specifies 16-bit data bus (i.e., wide transfer agreement)
02h Obsolete
03h - FFh Reserved
Table 19 defines valid combinations of TRANSFER WIDTH EXPONENT and other fields.
Timing values
Asynchronous.
39