1. Manuals
  2. Brands
  3. Seagate Manuals
  4. Storage
  5. U Series 9 CE
  6. Product manual

Seagate U Series 9 CE Product Manual

Seagate hard drive product manual
Hide thumbs Also See for U Series 9 CE:
Table of Contents

Advertisement

Quick Links

Download this manual
U Series 9 ce
ST3160022ACE
ST3120025ACE
ST380012ACE

Advertisement

Table of Contents
loading

Related Manuals for Seagate U Series 9 CE

Summary of Contents for Seagate U Series 9 CE

  • Page 1 U Series 9 ce ST3160022ACE ST3120025ACE ST380012ACE...
  • Page 3 U Series 9 ce ST3160022ACE ST3120025ACE ST380012ACE...
  • Page 4 Seagate Technology LLC. Other product names are registered trademarks or trademarks of their owners. Seagate reserves the right to change, without notice, product offerings or specifications. No part of this publication may be reproduced in any form without written permission of Seagate Technology LLC.
  • Page 5 Revision Date Rev. A 01/31/03 Rev. B 04/15/03 Rev. C 05/07/03 Rev. D 07/14/03 Rev. E 12/01/03 Rev. F 05/18/04 Revision status summary sheet Sheets Affected All. Page 24. Pages 6, 30-32, and 37-41 Pages 1, 4, 5, 7, 11, 12, and 13. Also new design and page size. Page 16.

  • Page 7: Table Of Contents

    Seagate Technology support services ........
  • Page 8 U Series 9 ce Product Manual, Rev. F...

  • Page 9: List Of Figures

    I/O pins and supported ATA signals ..........22 U Series 9 ce Product Manual, Rev. F...
  • Page 10 U Series 9 ce Product Manual, Rev. F...

  • Page 11: Introduction

    Introduction This manual describes the functional, mechanical and interface specifications for the following Seagate ® U Series 9 ce model drives: • ST3160022ACE • ST3120025ACE • ST380012ACE These drives provide the following key features: • High instantaneous (burst) data transfer rates (up to 100 Mbytes per second) using Ultra DMA mode 5.
  • Page 12 U Series 9 ce Product Manual, Rev. F...

  • Page 13: Drive Specifications

    Standby to ready (sec typical) Startup current (typical) 12V (peak) Track-to-track seek time (msec typical) Average seek, read (msec typical) Average seek, write (msec typical) Seek power (typical) U Series 9 ce Product Manual, Rev. F ST3160022ACE ST3120025ACE 312,581,808 234,441,648 16,383...
  • Page 14 1.0 G (0 to peak, 5–350 Hz) 5.0 Gs (0 to peak, 22–350 Hz) <2.5 (typical) 2.7 (max) 2.8 (typical) 3.0 (max) 1 per 10 bits read 600,000 5 Years 50,000 U Series 9 ce Product Manual, Rev. F ST380012ACE...

  • Page 15: Formatted Capacity

    Areal density (Mbits/inch max) Internal data-transfer rate OD (Mbytes/sec max) Sustained data transfer rate OD (Mbytes/sec max) I/O data-transfer rate (Mbytes/sec max) Interleave Cache buffer U Series 9 ce Product Manual, Rev. F Guaranteed sectors Bytes per sector 312,581,808 234,441,648 156,301,488...

  • Page 16: Physical Characteristics

    The drive receives DC power (+5V or +12V) through a four-pin standard drive power connector. 26.035 1.028 101.6 4.00 146.99 5.787 Read Write <1.0 <1.2 4.16 4.16 10 (max) 10 (max) 20 (max) U Series 9 ce Product Manual, Rev. F...

  • Page 17: Power Consumption

    Standby Sleep *During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. U Series 9 ce Product Manual, Rev. F Average 5V typ 12V typ (watts, 25° C)

  • Page 18: Typical Current Profile

    Typical 5V startup and operation current profile Amps Figure 1. Typical 12V startup and operation current profile +5 Volt Current during spindle start — Typical Amperes Seconds +12 Volt Current during spindle start — Typical Amperes Seconds U Series 9 ce Product Manual, Rev. F...

  • Page 19: Conducted Noise

    Each time the drive performs an Active function (read, write or seek), the standby timer is reinitialized and begins counting down from its specified delay times to zero. If the standby timer reaches zero before any drive U Series 9 ce Product Manual, Rev. F Spindle...

  • Page 20: Environmental Specifications

    Operating: 33°C (91.4°F max) Nonoperating: 40.0°C (104°F max) 2.10.4 Altitude Operating: –60.96 m to 3,048 m (–200 ft to 10,000+ ft) Nonoperating: –60.96 m to 12,192 m (–200 ft to 40,000+ ft) U Series 9 ce Product Manual, Rev. F...

  • Page 21: Shock

    Note. For seek mode tests, the drive is placed in seek mode only. The number of seeks per second is defined by the following equation: (Number of seeks per second = 0.4 / (average latency + average access time) U Series 9 ce Product Manual, Rev. F...

  • Page 22: Electromagnetic Immunity

    2.8 bels (typ) 3.0 bels (max) Performance level bits read, max. Reference standard EN 61000-4-2: 95 EN 61000-4-3: 96 ENV 50204: 95 EN 61000-4-4: 95 EN 61000-4-5: 95 EN 61000-4-6: 97 EN 61000-4-11: 94 U Series 9 ce Product Manual, Rev. F...

  • Page 23: Agency Certification

    As a subassembly, no Federal Communications Commission verification or certification of the device is required. Seagate Technology LLC has tested this device in enclosures as described above to ensure that the total assembly (enclosure, disc drive, motherboard, power supply, etc.) does comply with the limits for a Class B computing device, pursuant to Subpart J, Part 15 of the FCC rules.
  • Page 24 You may find helpful the following booklet prepared by the Federal Communications Commission: How to Identify and Resolve Radio-Television Interference Problems. This booklet is available from the Super- intendent of Documents, U.S. Government Printing Office, Washington, DC 20402. Refer to publication num- ber 004-000-00345-4. U Series 9 ce Product Manual, Rev. F...

  • Page 25: Configuring And Mounting The Drive

    • Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids the warranty. Some factory-installed labels contain information needed to service the drive. Other labels are used to seal out dirt and contamination. U Series 9 ce Product Manual, Rev. F...

  • Page 26: Breather Filter Hole Precautions

    Breather filter hole precautions This section contains information regarding the precautions which should be taken regarding the breather filter hole in Seagate hard disc drives. Proper precautions should be taken to ensure full functionality and prevent possible damage to the drive.

  • Page 27: Jumper Settings

    Report Full Capacity Available” causes Identify Data words 60 and 61 to report the full capacity. See Section 4.1.3 on page 28 for more details on the Set Features command. U Series 9 ce Product Manual, Rev. F Circuit Board ™...

  • Page 28: Ultra Ata/100 Cable

    • Do not use a drive interface cable that is more than 18 inches long. cable, attach the blue connector to the motherboard, the black connector to the master drive, and the gray connector to the slave. U Series 9 ce Product Manual, Rev. F...
  • Page 29 0.225 (5.72) max. fastener Recommended penetration both sides. 3 threads case temperature minimum engagement. measurement location Figure 1. Mounting dimensions—top, side and end view U Series 9 ce Product Manual, Rev. F 0.228 2.23 (5.79) (56.56) 2.83 (71.80) 3.71 (94.35) 5.787 max...
  • Page 30 U Series 9 ce Product Manual, Rev. F...

  • Page 31: Ata Interface

    ATA interface signals and connector pins Figure 1 on page 22 summarizes the signals on the ATA interface connector that the drive supports. For a detailed description of these signals, refer to the Draft ATA-6 Standard. U Series 9 ce Product Manual, Rev. F...
  • Page 32 Host Address Bus Bit 1 Passed Diagnostics Cable Assembly Type Identifier Device Address (2:0) Device Address (2:0) Chip Select (1:0) Chip Select (1:0) Drive Active/Slave Present Ground Host CSEL PDIAG – DASP– U Series 9 ce Product Manual, Rev. F...

  • Page 33: Supported Ata Commands

    Set Multiple Mode S.M.A.R.T. Write Buffer Write DMA Write DMA Extended Write Multiple Write Multiple Extended Write Sectors U Series 9 ce Product Manual, Rev. F Command code (in hex) Address: Password: Lock: Unlock: Freeze Lock:...
  • Page 34 Security Set Password Security Unlock Security Erase Prepare Security Erase Unit Security Freeze Lock Security Disable Password Command code (in hex) or E5 or E3 or E1 or E6 or E2 or E0 U Series 9 ce Product Manual, Rev. F...

  • Page 35: Identify Device Command

    Number of current logical cylinders Number of current logical heads Number of current logical sectors per logical track 57–58 Current capacity in sectors U Series 9 ce Product Manual, Rev. F ) transfers information about the drive to the host following Value 0C5A 16,383...
  • Page 36 0003 0078 0078 00F0 0078 0000 0000 0000 007E 0000 346B 7D01 4003 34xx 3xxx 4003 xx3F 0000 0000 FFFE xxxx 0000 ST3160022ACE = 312,581,808 ST3120025ACE = 234,441,648 ST380012ACE = 156,301,488 0000 U Series 9 ce Product Manual, Rev. F...
  • Page 37 Ultra DMA mode 2 is currently active. Ultra DMA mode 3 is currently active. Ultra DMA mode 4 is currently active. Ultra DMA mode 5 is currently active. U Series 9 ce Product Manual, Rev. F Value 0001 xxxx 0000...

  • Page 38: Set Features Command

    Enable read look-ahead (read cache) feature (default). Report full capacity available At power-on, or after a hardware or software reset, the default values of the features are as indi- Note. cated above. U Series 9 ce Product Manual, Rev. F...

  • Page 39: Commands

    S.M.A.R.T. Return Status If an appropriate code is not written to the Features Register, the command is aborted and 0x 04 Note. (abort) is written to the Error register. U Series 9 ce Product Manual, Rev. F ) that elimi-...
  • Page 40 U Series 9 ce Product Manual, Rev. F...

  • Page 41: Seagate Technology Support Services

    +1-405-324-4770. Presales, Technical Support and Warranty Service Presales Support Our Presales Support staff can help you determine which Seagate products are best suited for your specific application or computer system. Technical Support If you need help installing your drive, consult your system's documentation or contact the dealer's support ser- vices department for assistance specific to your system.
  • Page 42 Seagate service center representative for warranty-related issues. Resellers or end users of drive products should contact their place of purchase or one of the Seagate warranty service cen- ters for assistance. Have your drive’s “ST” model number and serial number available.

  • Page 43: Technical Support

    For product-specific phone number Hours of operation are 8:00 . to 8:00 Hours of operation are 8:30 . to 12:15 Authorized Service Center U Series 9 ce Product Manual, Rev. F Direct dial +1-405-324-4730 Direct dial +1-405-324-4700 Direct dial +1-405-324-4720...
  • Page 44 00 800-47324289 00 800-47324289 00 800-47324289 00 800-311 12 38 00 800-47324289 00 800-47324289 00 800-47324289 00 800-31 92 91 40 00 800-47324289 . to 5:00 . (Central Europe time) Mon- U Series 9 ce Product Manual, Rev. F . to...
  • Page 45 5:30 Hours of operation are 9:00 to 6:00 Hours of operation are 9:30 to 6:30 Authorized Service Center U Series 9 ce Product Manual, Rev. F . to 10:45 . and 12:00 . to 6:00 Direct dial — +86-10-6225-5336 —...
  • Page 46 U Series 9 ce Product Manual, Rev. F...
  • Page 47 CSA C22.2 (950) 13 CSEL 17 C-Tick 13 current profile 8 cycles 12 Data Defense 1 U Series 9 ce Product Manual, Rev. F data-transfer rates 1 DC power 6 density 5 Diagnostic Defense 1 diagnostic software 1 discs 5...
  • Page 48 28 relative humidity 10 reliability 12 resistance 9 resistive load 9 RF 12 S.M.A.R.T. 23 S.M.A.R.T. commands 29 S.M.A.R.T. drive monitoring 1 safety certification 13 screws 18 SeaShell 15 SeaTools 1 U Series 9 ce Product Manual, Rev. F...
  • Page 49 5 track-to-track seek time 6 TUV North America 13 UL 1950 13 Ultra ATA/100 18 Ultra DMA 18 U Series 9 ce Product Manual, Rev. F vibration 11 voltage 9 voltage dips, interrupts 12 voltage tolerance 9 weight 6...
  • Page 50 U Series 9 ce Product Manual, Rev. F...
  • Page 52 Seagate Technology LLC 920 Disc Drive, Scotts Valley, California 95066-4544, USA Publication Number: 100271705, Rev. F, Printed in USA...

This manual is also suitable for:

St380012ace - u series ce 80 gb hard driveSt3160022aceSt3120025aceSt380012ace

Table of Contents