Table of Contents
Advertisement
SCSI Interface Product Manual, Rev. B
8.9.5
Factory Log page (3Eh)
Log page code 3Eh specifies factory status parameters.
Table 122:
Factory Log page (3Eh)
Bit
7
Byte
0
0
1
PARAMETER CODE [1] [2]
[1]
PARAMETER CODE 0000h–Power-on Time. This parameter code represents the number of drive power-
on minutes. Currently the Power-on Time parameter (0000h) is the only parameter in this Log Page that is
visible to OEM/customers.
[2]
PARAMETER CODE 08h. This parameter reports the time, in minutes, to the next scheduled interrupt for
a S.M.A.R.T. measurement (see Section 9.1).
8.9.6
Last n Deferred Errors or Asynchronous Events page (0Bh)
Log page (0Bh) provides for a number of deferred errors or asynchronous events sense data records using the
list parameter format of the log page. The number of these deferred errors or asynchronous events records
supported, n, is vendor-specific. Each deferred error or asynchronous event record contains SCSI sense data
for a deferred error or asynchronous event that has occurred. The parameter code associated with the record
indicates the relative time at which the deferred error or asynchronous event occurred. A higher parameter
code indicates that the deferred error or asynchronous event occurred later in time.
The content of the parameter value field of each log parameter is the SCSI sense data describing the deferred
error.
The fields DU, TSD, ETC, and TMC are reserved and shall be set to zero. The LBIN bit shall be set to one
(binary information). The LP bit shall be set to one (list parameter).
8.9.7
Last n error events page (07h)
Log page (07h) provides for a number of error-event records using the list parameter format of the log page.
The number of these error-event records supported, n, is vendor-specific. Each error-event record contains
vendor-specific diagnostic information for a single error encountered by the device. The parameter code asso-
ciated with error-event record indicates the relative time at which the error occurred. A higher parameter code
indicates that the error event occurred later in time.
The content of the parameter value field of each log parameter is an ASCII character string which may
describe the error event. The exact contents of the character string is not defined at this time.
8.9.8
Non-medium Error page (06h)
Log page code 06h specifies non-medium errors. The page format is shown in Table 123.
Table 123:
Non-medium Error page (06h)
Bit
7
Byte
0
0
1
PARAMETER CODE [1]
[1]
PARAMETER CODE 00h is the only code supported for this page and it represents the number of recov-
erable error events other than write, read, or verify errors.
8.9.9
Self-test Results Log page (10h)
The Self-test Results Log page (see Table 124) provides the results from the twenty most recent self-tests (see
Section 9.2). Results from the most recent self-test or the self-test currently in progress shall be reported in the
6
5
0
0
6
5
0
0
4
3
0
0
4
3
0
0
2
1
0
0
2
1
0
0
183
0
0
0
0
Advertisement
Table of Contents
