Table of Contents
Advertisement
QoS
You can specify the priority to secure a stable transfer rate for a specific IP.
1. From the Setup menu, select the
<network (
)> tab.
2. Click <QoS>.
3. Click the [add (
The IP list will be created.
4. Enter an IP address to which you will
apply QoS.
The default prefix for IPv4 is 32;
`
M
For DSCP, the default is set to 63.
Only the IP addresses that are set to <Use> can be prioritized.
`
5. Select an IP to delete from the list.
Click the [Delete (
6. When done, click [apply (
Snmp
With the SNMP protocols, the system or network admin can monitor the network devices
on a remote site, and configure the environment settings.
1. From the Setup menu, select the
<network (
)> tab.
2. Click <Snmp>.
3. Specify the <Snmp>.
• Enable SNMP v1 : SNMP version 1
will be active.
• Enable SNMP v2c : SNMP version 2
will be active.
- Read community : Provide the
name of the read community where
you can access to the SNMP information.
The default name is <public>.
- Write community : Provide the name of the write community where you can
access to the SNMP information. The default name is <write>.
)] button.
)] button.
)].
English _99
Advertisement
Table of Contents
