Level Control - Krell Industries PHANTOM User Manual

(SECTION FOUR: Anatomy of an Phantom continued)
3 Using the reference channel/channel combination SPL figure, raise or lower
remaining channels/channel combinations to match the reference
channel/channel combinaion SPL. The range of adjustments is +/- 12dB for
each channel/channel combination.
4. To exit pink noise generator mode, press and hold Mute button (12) on front
panel until
PINK NOISE GENERATOR
mute button LED stops blinking.
Note: The pink noise generator is only active if optional crossover board
is installed.
13 Phase Button and LED, or Key
Use this button or key to invert the absolute polarity of the main output by 180
degrees. The red phase LED illuminates, when phase is selected.
Display
3 Front Panel Display
The front panel display provides preamplifier channel status messages, includ-
ing input status, tape output status, volume level, balance offset, and menu
selections.

Level Control

14 Level Control Knob or Level Keys
Use this knob or keys to increase or decrease system volume level or, with the
balance key (C), to adjust balance. The level control knob or keys also select
menu options that customize the Phantom. See Customizing the Phantom,
on page 31.
Navigate/Customize
5 Menu Button or Key
Use this button or key to access the menu functions of the Phantom. For more
information, see Customizing the Phantom, on page 31.
6 Enter Button or Key
Use this button or key to configure the menu functions of the Phantom. For
more information, see Customizing the Phantom, on page 31.
disappears from front panel display (3) and the
19