Table of Contents
Advertisement
9. Configuring the Multiface
9.1 General Information
Configuring the HDSP system is done using its own settings dialog. The panel 'Settings' can be
opened in two different ways:
by clicking on the hammer icon in the Taskbar's system tray
by starting the 'HDSP_Set' link from the Desktop
The mixer of the Hammerfall DSP System (TotalMix) can be opened in two different ways:
by clicking on the mixer icon in the Taskbar's system tray
by starting the 'HDSP_Mix' link from the Desktop
The Hammerfall DSP's hardware offers a number of helpful, well thought-of practical functions
and options which affect how the card operates - it can be configured to suit many different
requirements. The following is available in the 'Settings' dialog:
Input selection
Output mode
Output channel status
Synchronization behaviour
Input and output status display
Time code display
Any changes made in the Settings
dialog are applied immediately -
confirmation (e.g. by clicking on
OK or exiting the dialog) is not
required. However, settings should
not be changed during playback or
record if it can be avoided, as this
can cause unwanted noises. Also,
please note that even in 'Stop'
mode, several programs keep the
recording and playback devices
open, which means that any new
settings might not be applied
immediately.
The status displays at the bottom
of the dialog box give the user
precise information about the current status of the system, and the status of all signals.
'SyncCheck' indicates whether there is a valid signal for each input ('Lock' or 'No Lock'), or if
there is a valid and synchronous signal ('Sync'). The 'AutoSync Ref' display shows the input
and frequency of the current sync source.
'Time Code' displays time information received from the I/O-box ADAT Sync port. This is
convenient for checking whether the system is running in time with the transmitting device (e.g.
ADAT).
User's Guide HDSP System Multiface © RME
15
Advertisement
Table of Contents
