Configuring The Hdsp 9632; General Information - RME Audio Hammerfall HDSP 9632 User Manual

9. Configuring the HDSP 9632

9.1 General Information

Configuring the HDSP 9632 is done via its own settings dialog. The panel 'Settings' can be
opened:
by clicking on the hammer icon in the Taskbar's system tray
The mixer of the Hammerfall DSP System (TotalMix) can be opened:
by clicking on the mixer icon in the Taskbar's system tray
The Hammerfall DSP's hardware offers a number of helpful, well thought-of practical functions
and options which affect how the card operates - it can be configured to suit many different
requirements. The following is available in the 'Settings' dialog:
Input selection
Output mode
Output channel status
Synchronization behaviour
Input and output status display
Any changes made in the Settings
dialog are applied immediately -
confirmation (e.g. by clicking on OK
or exiting the dialog) is not required.
However, settings should not be
changed during playback or record
if it can be avoided, as this can
cause unwanted
please note that even in 'Stop'
mode, several programs keep the
recording and playback devices
open, which means that any new
settings might not
immediately.
The status displays at the bottom of the dialog box give the user precise information about the
current status of the system, and the status of all signals. 'SyncCheck' indicates whether there
is a valid signal for each input ('Lock' or 'No Lock'), or if there is a valid and synchronous signal
('Sync'). The 'AutoSync Ref' display shows the input and frequency of the current sync source.
noises. Also,
be applied
User's Guide Hammerfall DSP 9632 © RME
17